A novel coupled FDM-DEM modelling method for flexible membrane boundary in laboratory tests

Difficulties are involved in discrete element method (DEM) modelling of the flexible boundary, that is, the membranes covering the soil sample, which can be commonly found in contemporary laboratory soil tests. In this paper, a novel method is proposed wherein the finite difference method (FDM) and DEM are coupled to simulate the rubber membrane and soil body, respectively. Numerical plane strain and triaxial tests, served by the flexible membrane, are implemented and analysed later. The effect of the membrane modulus on the measurement accuracy is considered, with analytical formulae derived to judge the significance of this effect. Based on an analysis of stress-strain responses and the grain rotation field, the mechanical performances produced by the flexible and rigid lateral boundaries are compared for the plane strain test. The results show that (1) the effect of the membrane on the test result becomes more significant at larger strain level because the membrane applies additional lateral confining pressure to the soil body; (2) the tested models reproduce typical stress and volumetric paths for specimens with shear bands; (3) for the plane strain test, the rigid lateral boundary derives a much higher peak strength and larger bulk dilatation, but a similar residual strength, compared with the flexible boundary. The latter produces a more uniform (or ‘diffuse') rotation field and more mobilised local kinematics than does the former. All simulations show that the proposed FDM-DEM coupling method is able to simulate laboratory tests with a flexible boundary membrane.     

乌鲁木齐大气混合层厚度和稳定度与大气污染的关系

利用乌鲁木齐市4座10层100 m梯度气象塔2013年6月~2014年4月气象观测资料和7个环境监测站[WTBX]AQI[WTBZ]资料，计算并分析了大气混合层厚度和稳定度特征，探讨了大气混合层厚度和稳定度与污染的关系。结果表明：乌鲁木齐市混合层厚度夏季郊区高、城区低，冬季从南郊—城区—北郊随地势降低依次降低；夏季和冬季分别在1 559～1 772 m和526～1 156 m之间。地面至2 km以上每500 m高度间隔统计混合层厚度，500～1 000 m出现频率最多；月变化为6～9月基本在500 m以上，且每个高度区间其概率均超过10%，10月～次年2月1 500 m以上区间概率明显减小；日变化为中午13:00～16:00达到最高值，下午和傍晚迅速下降。白天较大的感热输送提供充足的热力条件，这也体现出白天以不稳定层结为主，夜间则以稳定层结为主。大气稳定度分类结果，夏季郊区和城区不稳定（A～C类）所占比例差不多，冬季北郊稳定（E、F类）所占比较最大、城区最弱。[WTBX]AQI指数冬季最大，从南郊—城区—北郊依次增大，这与采暖期污染物多、南郊比北郊地势高有利于扩散输送有关。总体来看，乌鲁木齐大气混合层厚度空间分布与气象要素、大气稳定度、地形等密切相关，对AQI[WTBZ]指数分布有重要影响，这对近地层大气污染状况预报有着重要的指导意义。     

沉积物中硬质粘土层的研究进展

大量的钻孔资料表明,平原地区及其海域沉积物中普遍有硬质粘土层的存在。硬质粘土层在工程地质、地理学研究等方面具有重要的价值,它不仅是高层建筑的持力层,而且是研究全球环境变化事件、古气候演变的良好载体。该文阐述了硬质粘土层的一般特征、成因以及在粒度、地球化学元素、年代学、沉积环境等方面的研究进展,并展望了硬质粘土层在年代、物质来源和沉积环境等方面的研究方向,认为黄河三角洲硬质粘土层研究较少,需要开展大范围的、系统深入的、多学科的宏观和微观综合分析,挖掘硬质粘土层蕴含的古环境意义和应用价值。     

Explicit stress–strain equations for modeling frictional materials

In this paper, a comprehensive study on simulating the shearing behavior of frictional materials is performed. A set of two explicit equations, describing the relationship among the shear stress ratio and the distortional strain and the volumetric strain, are formulated independently. The equations contain three stress parameters and three strain parameters and another parameter representing the nonuniformity of stress and strain during softening. All the parameters have clear physical significance and can be determined experimentally. It is demonstrated that the proposed equations have the capacity of simulating the complicated shearing behavior of many types of frictional materials including geomaterials. The proposed equations are used to simulate the stress–strain behavior for 27 frictional materials with 98 tests. These materials include soft and stiff clays in both reconstituted and structured states, silicon sands and calcareous sands, silts, compacted fill materials, volcanic soils, decomposed granite soils, cemented soils (both artificially and naturally cemented), partially saturated soils, ballast, rocks, reinforced soils, tire chips, sugar, wheat, and rapeseed. It has been demonstrated that the proposed explicit constitutive equations have the capacity to capture accurately the shearing behavior of frictional materials both qualitatively and quantitatively. A study on model parameters has been performed.     

The Upper Devonian Kellwasser event recorded in a regressive sequence from inner shelf to lagoonal pond,Catalan Coastal Ranges,Spain

This study, conducted in the Catalan Coastal Ranges, north‐east Spain, describes the Upper Devonian Kellwasser event in a shallowing‐upward sequence of black shales, siltstones and quartz arenites. This sequence was deposited in a progradational and regressive coastal system where the sedimentary environment evolved from the inner shelf to a lagoonal pond located landward of the shoreline. Three anomalous succeeding steps have been identified by geochemical analysis. The first one, detected on the inner shelf, was characterized by oxygen depletion and high organic productivity. The second, detected in the nearshore, was caused by hydrothermal activity occurring under normal oxic conditions. The third and most intense step was identified in the muds of the lagoonal pond and has been linked to strong anoxic conditions, elevated clastic input derived from changes in the weathering regime at the source area and moderate hydrothermal activity. The Kellwasser event is thus defined in the study area as stepwise and multi‐causal. This is the first time that the Kellwasser event has been identified in a sedimentary environment behind the shoreline. It is also the first time that it has been reported in the Catalan Coastal Ranges.     

敦煌-格尔木铁路沿线风动力环境特征

敦煌-格尔木铁路沿线地形复杂、起沙因素多变、沙源丰富，沙害问题日益严重。目前对其风沙活动规律还未有研究，不利于防沙工作的开展。为此，通过对自北向南的5个观测点（S1、S2、S3、S4、S5）风速和风向的观测、计算和分析，利用平均风速、起沙风况及输沙势对敦格铁路沿线的风动力环境特征进行研究。结果表明：S5、S4和S3的风况对铁路风沙灾害防治意义较大。S5年平均风速、起沙风频率和输沙势最大，春季风沙活动最为强烈，且风向单一、风力强劲，风沙运动方向基本与铁路垂直，沙粒易在铁路附近堆积。S4夏季风沙活动最为强烈；S3春季风沙活动最为强烈，且风向单一，S4和S3的风沙运动方向与铁路夹角小于90°，附近沙源广阔，铁路易受风沙侵蚀，阻碍交通运营。     

有关边界层问题中一类奇异积分方程新的存在性结果

对边界层理论新结果中出现的一类奇异积分方程w（t）=∫1 t（1-s）（λ＋λs＋s）/w（s）ds＋（1-t）∫t 0s/w（s）ds,t∈（0,1）进行讨论，并得出了上述方程在λ∈（-1/2,0）上正解存在性的新结果。     

Multiple longshore sand bars in the upper Chesapeake Bay

In the upper Chesapeake Bay (Maryland, U.S.A.) field surveys were conducted at 18 multiple longshore sand bar sites. The multiple bar systems were found in water depths less than approximately 2 m (mean sea level), and exhibited mild bottom slopes of 0·0052 or less. The number of bars composing each system ranged from four to 17 and the spacing between the crests typically increased in the offshore direction, ranging from 12 to 70 m. Bar height also typically increased with distance offshore and ranged from 0·03 to 0·61 m. A grain size analysis of crest and trough sediment did not reveal any significant differences and the sediment was categorized as ‘fine sand’. A review of the literature data indicated that the Chesapeake Bay multiple bars possessed similar characteristics to those found in Gelding Bay (Baltic Sea); similarities in fetch, wave height and tidal range between the two bays may account for this finding. The surf-scaling parameter indicated that the multiple bar systems were extremely dissipative with regard to wave energy, and wave height appeared to be an important factor in controlling bar spacing and bar height. A multiple wave break point hypothesis was discussed as a possible mechanism for the formation of Chesapeake Bay multiple longshore bars, and limited observational evidence appeared to support such a mechanism.     

Strain localization in sand: an overview of the experimental results obtained in Grenoble using stereophotogrammetry

Experimental results are presented from the extensive program of drained plane strain compression tests on sand carried out in Grenoble over the last two decades. Systematic analysis of photographs of the deforming specimen allowed for measuring deformations and determining strain fields throughout the test, that is: prior to, at, and after the onset of strain localization. The principles, details and accuracy of the procedure are described, as well as its suitability to properly depict the patterns of deformation. Findings concerning the occurrence and progression of strain localization are discussed. The issues of shear band orientation and thickness are addressed, as well as temporary and persistent complex localization patterns, and the volumetric behaviour inside a band after its formation. The influence of such variables as initial state of the sand (effective stress and relative density), specimen size and slenderness, as well as grain size, is discussed. Copyright © 2004 John Wiley & Sons, Ltd